Interfaces Hybrid Crossover - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

interfaces hybrid crossover

Configures port crossover settings on a single port, a range of ports, or an entire Network Interface (NI).
interfaces slot[/port[-port2]] hybrid copper crossover {auto | mdix | mdi}
Syntax Definitions
slot
port
port2
copper
auto
mdix
mdi
Defaults
parameter
auto | mdix | mdi
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
You cannot configure crossover settings on fiber ports. These ports use the MDI standard.
•
The MIB table and MIB object listed in the "MIB Objects" section below apply to the inactive config-
ured media only. See the "MIB Objects" section in the
and MIB object for the active configured media.
Examples
-> interfaces 1/25 hybrid copper crossover disable
-> interfaces 1/25-26 hybrid copper crossover mdix
-> interfaces hybrid copper crossover auto
Release History
Release 6.6.1; command was introduced.
page 20-28
Slot number you want to configure.
Port number of the interface you want to configure.
Last port number in a range of ports you want to configure.
Specifies that changes will be made to the copper RJ-45 port(s).
The interface will automatically detect crossover settings.
Sets the crossover configuration to Media Dependent Interface with
Crossover (MDIX), which is the standard for hubs and switches.
Sets the crossover configuration to Media Dependent Interface (MDI),
which is the standard for end stations.
default
auto
OmniSwitch 6250 CLI Reference Guide
interfaces crossover section for the MIB table
Ethernet Port Commands
November 2009