Loopback-Detection Autorecovery-Timer - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

loopback-detection autorecovery-timer

Configures the LBD autorecovery timer on the switch. The autorecovery time is the time period in seconds
that passes after which ports that were shut down through LBD are moved to normal state or inactive state,
depending on the parameter that is set on the switch.
loopback-detection autorecovery-timer seconds
Syntax Definitions
seconds
Defaults
parameter
seconds
Platforms Supported
OmniSwitch 6250-Metro Models
Usage Guidelines
•
If the autorecovery timer value is not configured, the default value of 300 seconds is assigned to the
autorecovery period.
•
The timer can be modified at any time. However, the new timer value will come into effect only after
the timer is restarted.
Examples
-> loopback-detection autorecovery-timer 300
Release History
Release 6.6.1; command was introduced.
Related Commands
loopback-detection
show loopback-detection
MIB Objects
alaLdbConfigTable
alaLdbGLobalConfigAutorecoveryTimer
page 17-6
The LBD autorecovery timer in seconds. The valid range is from 30 to
86400 seconds.
default
300
Enables or disables LBD globally on the switch.
Displays LBD configuration information.
OmniSwitch 6250 CLI Reference Guide
Loopback Detection Commands
November 2009