Ethernet-Service Uni Uni-Profile - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

VLAN Stacking Commands

ethernet-service uni uni-profile

Associates a VLAN Stacking User Network Interface (UNI) profile with a UNI port.
ethernet-service uni {slot/port1[-port2] | agg_num} uni-profile uni-profile-name
Syntax Definitions
slot/port1
-port2
agg_num
uni-profile-name
Defaults
The default profile (default-uni-profile) is used to process control packets ingressing on a UNI port. This
profile is assigned at the time a port is configured as a VLAN Stacking UNI.
Platforms Supported
OmniSwitch 6250-Metro Models
Usage Guidelines
•
This UNI specified with this command must already exist in the switch configuration.
•
To change the profile associated with a UNI port, use this command and specify a different profile
name than the one currently associated with the port. The last profile associated with the port, is the
profile that is applied to UNI port traffic.
•
To change the profile associated with a UNI port back to the default profile, enter "default-uni-profile"
with this command.
Examples
-> ethernet-service uni 1/3 uni-profile uni_1
-> ethernet-service uni 2/10-15 uni-profile default-uni-profile
-> no ethernet-service uni 1/3 uni-profile uni_1
Release History
Release 6.6.1; command was introduced.
OmniSwitch CLI Reference Guide
The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
The last port number in a range of ports that you want to configure on
the same slot (e.g, 3/1-4 specifies ports 1, 2, 3, and 4 on slot 3).
The link aggregate ID number (0–31).
Alphanumeric string of up to 32 characters. Use quotes around string if
the profile name contains multiple words with spaces between them
(e.g., "Alcatel-Lucent Engineering").
November 2009 page 24-27