Whoami - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

Session Management Commands

whoami

Displays the current user session.
whoami
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
Use the who command to display all sessions on the switch.
Examples
-> whoami
Session number = 5
User name = admin,
Access type = telnet,
Access port = NI,
IP address = 121.251.17.76,
Read-only domains
Read-only families
Read-Write domains
Read-Write families = ,
End-User profile
output definitions
Session Number
User name
Access type
Access port
Ip Address
Read-only domains
Read-only families
Read-Write domains
OmniSwitch 6250 CLI Reference Guide
= None,
= ,
= All ,
=
The session number assigned to the user.
User name.
Type of access protocol used to connect to the switch.
Switch port used for access during this session.
User IP address.
The command domains available with the user's read-only access. See
the table beginning on
The command families available with the user's read-only access. See
the table beginning on
The command domains available with the user's read-write access. See
the table beginning on
November 2009
page 6-28 for a listing of valid domains.
page 6-28 for a listing of valid families.
page 6-28 for a listing of valid domains.
page 6-27