Show Spantree 1X1 - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

show spantree 1x1

Displays Spanning Tree bridge information for a 1x1 mode VLAN instance.
show spantree 1x1 [vid]
Syntax Definitions
vid
Defaults
parameter
vid
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
If a vid number is not specified, this command displays the Spanning Tree status, protocol, and priority
values for all VLAN instances.
•
Specify a vid number with this command to display Spanning Tree bridge information for a specific
VLAN instance.
•
Specifying a range of VLAN IDs is also allowed. Use a hyphen to indicate a contiguous range (e.g.,
show spantree 1x1 10-15). Note that only one VLAN entry—a single VLAN ID or a range of VLAN
IDs— is allowed with this command. Multiple entries are not accepted.
•
This is an explicit Spanning Tree command that displays Spanning Tree bridge information for a
VLAN instance regardless of which mode (1x1 or flat) is active on the switch. Note that minimal infor-
mation is displayed when this command is used in the flat mode, as VLAN instances are not active in
this mode.
Examples
-> show spantree 1x1
Spanning Tree Path Cost Mode : AUTO
Vlan STP Status Protocol Priority
-----+----------+--------+--------------
1 ON
2 ON
3 ON
4 ON
5 ON
6 ON
page 16-132
An existing VLAN ID number (1-4094).
default
all VLAN instances
STP 32768 (0x8000)
STP 32768 (0x8000)
STP 32768 (0x8000)
STP 32768 (0x8000)
STP 32768 (0x8000)
STP 32768 (0x8000)
OmniSwitch 6250 CLI Reference Guide
Distributed Spanning Tree Commands
November 2009