Interfaces Hybrid Speed - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

interfaces hybrid speed

Configures interface line speed on combo ports.
interfaces slot[/port[-port2]] speed hybrid {fiber | copper} {auto | 10 | 100 | 1000 | 10000 | max {100 |
1000}}
Syntax Definitions
slot
port
port2
fiber
copper
auto
10
100
1000
10000
max 100
max 1000
Defaults
parameter
auto | 10 | 100 | 1000 |
10000 | max 100 | max
1000
Platforms Supported
OmniSwitch 6250
Usage Guidelines
The MIB table and MIB object listed in the "MIB Objects" section below apply to the inactive configured
media only. See the "MIB Objects" section in the
object for the active configured media.
page 20-32
Slot number you want to configure.
Port number of the interface you want to configure.
Last port number in a range of ports you want to configure.
Specifies that configuration changes will be made to the SFP port(s).
Specifies that changes will be made to the copper RJ-45 port(s).
The switch will automatically set the line speed to match the attached
device (auto-sensing).
Sets the interface to 10 Mbps.
Sets the interface to 100 Mbps.
Sets the interface to 1 Gigabit.
Sets the interface to 10 Gigabit. This option is currently not supported.
Sets the maximum speed to 100 megabits.
Sets the maximum speed to 1000 megabits (1 Gigabit)
default
auto
interfaces speed
OmniSwitch 6250 CLI Reference Guide
Ethernet Port Commands
section for the MIB table and MIB
November 2009