Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual page 573

Distributed Spanning Tree Commands
-> show spantree 1x1 7
Spanning Tree Parameters for Vlan 7
Spanning Tree Status :
Protocol
mode
Priority
Bridge ID
Designated Root
Cost to Root Bridge
Root Port
Next Best Root Cost
Next Best Root Port
Tx Hold Count
Topology Changes
Topology age
Current Parameters (seconds)
Max Age
Forward Delay
Hello Time
Parameters system uses when attempting to become root
System Max Age
System Forward Delay =
System Hello Time
-> show spantree 1x1 10-15
Spanning Tree Path Cost Mode : AUTO
Vlan STP Status Protocol Priority
-----+----------+--------+--------------
10 ON
11 ON
12 ON
13 ON
14 ON
15 ON
output definitions
Spanning Tree Path Cost
Mode
Vlan
STP Status
Protocol
Mode
Priority
Bridge ID
OmniSwitch 6250 CLI Reference Guide
: IEEE STP,
: 1X1 (1 STP per Vlan),
: 32768 (0x8000),
: 8000-00:d0:95:6a:f4:58,
: 0000-00:00:00:00:00:00,
:
: Slot 1 Interface 1,
:
: Slot 1 Interface 1,
:
:
: 00:00:00,
= 20,
= 15,
= 2
= 20,
15,
= 2
RSTP 32768 (0x8000)
RSTP 32768 (0x8000)
RSTP 32768 (0x8000)
RSTP 32768 (0x8000)
RSTP 32768 (0x8000)
RSTP 32768 (0x8000)
The Spanning Tree path cost mode for the switch (32 BIT or AUTO)
Configured through the
The VLAN ID associated with the VLAN Spanning Tree instance.
Configured through the
The Spanning Tree state for the instance (ON or OFF).
The Spanning Tree protocol applied to the VLAN instance (STP or
RSTP). Note that MSTP is not supported for a VLAN instance. Con-
figured through the
The Spanning Tree operating mode for the switch (1x1 or flat). Config-
ured through the
The Spanning Tree bridge priority for the instance. The lower the num-
ber, the higher the priority. Configured through the
command.
The bridge identifier for this Spanning Tree instance. Consists of the
bridge priority value (in hex) concatenated with the dedicated bridge
MAC address.
November 2009
ON,
0,
0,
6,
0,
bridge path cost mode
vlan commands
bridge protocol command.
bridge mode command.
command.
bridge priority
page 16-133