Ethoam Association Mhf - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

Ethernet OAM Commands

ethoam association mhf

Modifies the MIP Half Function
ethoam association association_name domain {domain_name | mac_address} mhf {none | explicit |
default}
Syntax Definitions
association_name
domain_name
mac_address
none
explicit
default
Defaults
parameter
none | explicit | default
Platforms Supported
OmniSwitch 6250
Usage Guidelines
The association_name should be unique amid all those used by or available to the service provider within
a domain.
Examples
-> ethoam association alcatel-sales domain esd.alcatel-lucent.com mhf none
Release History
Release 6.6.1; command was introduced.
OmniSwitch 6250 CLI Reference Guide
(
MHF) value of an Ethernet OAM Maintenance Association.
Name of the Ethernet OAM Association. Up to 48 (minus the domain
name length) characters may be used.
Specifies the domain name. For more information on the different
formats of the domain name, refer to
page 25-3.
Specifies the CFM system MAC address.
Specifies that no MHFs can be created for the specified VLAN ID.
Specifies that MHFs can be created for the specified VLAN ID only on
Bridge ports through which this VLAN ID can pass and only if a Main-
tenance End Point (MEP) is created at a lower MA level.
Specifies that MHFs can be created on the specified VLAN ID on any
Bridge port through which this VLAN ID can pass.
default
none
November 2009
ethoam domain command on
page 25-9