Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual page 89

Chassis Management and Monitoring Commands
output definitions (continued)
Manufacture Date
Firmware Version
Admin Status
Operational Status
Power Consumption
Power Control Checksum
MAC Address
Release History
Release 6.6.1; command was introduced.
Related Commands
show chassis
show ni
show module
show module long
show module status
show system
OmniSwitch 6250 CLI Reference Guide
The date the board was manufactured.
The firmware version for the board's ASICs.
The current power status of the CMM. Because information is obtained
from a running CMM, the value will always be POWER ON.
The current operational status of the CMM.
The current power consumption for the CMM.
The current power control checksum for the corresponding CMM.
The MAC address assigned to the chassis. This base chassis MAC
address is a unique identifier for the switch and is stored on an
EEPROM card in the chassis. It is not tied to the CMM. Therefore, it
will not change if the CMM is replaced or becomes secondary. The
MAC address is used by the Chassis MAC Server (CMS) for allocation
to various applications. Refer to the "Managing MAC Addresses and
Ranges" chapter of the OmniSwitch 6250 Switch Management Guide
for more information.
Displays the basic configuration and status information for the switch
chassis.
Displays the basic hardware and status information for Network Inter-
face (NI) modules currently installed in the switch.
Displays the basic information for either a specified module or all the
modules installed in the chassis.
Displays the detailed information for either a specified module or all
modules installed in the chassis.
Displays the basic status information for either a specified module or all
modules installed in the chassis.
Displays basic system information for the switch.
November 2009 page 2-37