Show Ntp Client - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

show ntp client

Displays information about the current client NTP configuration.
show ntp client
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
This command displays the current configuration parameters for the NTP client. The display is slightly
different depending on what has been configured on the client. See the Examples section for more infor-
mation.
Examples
-> show ntp client
Current time:
Last NTP update:
Client mode:
Broadcast client mode:
Broadcast delay (microseconds): 4000
output definitions
Current time
Last NTP update
Client mode
Broadcast client mode
Broadcast delay
Release History
Release 6.6.1; command was introduced.
page 5-12
SAT APR 16 2005 00:19:02 (UTC)
SAT APR 16 2005 00:06:45 (UTC)
enabled
disabled
The current time for the NTP client.
The time of the last synchronization with an NTP server.
Whether the NTP client software is enabled or disabled.
What NTP mode the client is running in, either client or broadcast.
The number of microseconds in the advertised broadcast delay time.
This field is absent if the client broadcast mode is disabled.
OmniSwitch 6250 CLI Reference Guide
Network Time Protocol Commands
November 2009