Lldp Tlv Dot1 - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

802.1AB Commands

lldp tlv dot1

Specifies the switch to control per port 802.1 TLVs to be incorporated in the LLDPDUs.
lldp {slot/port | slot | chassis} tlv dot1 {port-vlan | vlan-name} {enable | disable}
Syntax Definitions
slot/port
slot
port-vlan
vlan-name
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
The LLDPDU must be enabled and set to transmit before using this command.
•
If this command is applied to a slot or chassis, then the existing configuration related to this command
will be lost.
•
If one TLV is included then the other TLV is automatically included when you use this command.
Examples
-> lldp 5/1 tlv dot1 port-vlan enable
-> lldp 3 tlv dot1 vlan-name enable
-> lldp 3 tlv dot1 vlan-name disable
Release History
Release 6.6.1; command was introduced.
OmniSwitch 6250 CLI Reference Guide
Slot number for the module and physical port number on that module
(e.g., 3/1 specifies port 1 on slot 3).
The slot number for a specific module.
Enables or disables transmission of port VLAN TLV in LLDPDU.
Enables or disables transmission of VLAN name TLV in LLDPDU.
Enables 802.1 TLV LLDPDU transmission.
Disables 802.1 TLV LLDPDU transmission.
default
disable
November 2009 page 13-13