Port-Security - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

port-security

Enables or disables Learned Port Security (LPS) on the switch port(s). When LPS is enabled, only devices
that have a source MAC address that complies with LPS restrictions are learned on the port(s).
port-security slot/port[-port2] [enable | disable]
port-security chassis disable
no port security slot/port[-port2]
Syntax Definitions
slot/port
-port2
enable
disable
chassis disable
Defaults
By default, LPS is disabled on all switch ports.
parameter
enable | disable
Platforms Supported
OmniSwitch 6250
page 19-2
The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
The last port number in a range of ports you want to configure on the
same slot (e.g, 3/1-4 specifies ports 1-4 on slot 3).
Enables LPS on the specified port(s).
Disables LPS on the specified port(s).
Disables all LPS-eligible ports on the chassis.
default
enable
OmniSwitch 6250 CLI Reference Guide
Learned Port Security Commands
November 2009