Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual page 813

VLAN Management Commands
Mobile Tag
Source Learning
Traffic-Type: ethernet-service Customer SVLAN,
Priority-Map: x->0
output definitions
vlan
type
admin
oper
stree 1x1
stree flat
auth
ip
mble tag
src lrn
name
Traffic-Type
Priority-Map
OmniSwitch 6250 CLI Reference Guide
: off,
: disabled,
The numerical VLAN ID. Use the
VLANs.
The type of VLAN (std, vstk, gvrp, or ipmv).
VLAN administrative status: on enables VLAN functions to operate;
off disables VLAN functions without deleting the VLAN. Use the
command to change the VLAN administrative status.
VLAN operational status: on (enabled) or off (disabled). The opera-
tional status remains disabled until an active port is assigned to the
VLAN. When the operational status is enabled, then VLAN properties
(e.g. router interfaces, Spanning Tree) are applied to ports and traffic
flow. A VLAN must have an enabled administrative status before it can
become operationally enabled.
VLAN Spanning Tree status for the VLAN in the 1x1 mode: on
(enabled) allows the Spanning Tree algorithm to determine the state of
VLAN ports (forwarding or blocking); off (disabled) prevents Span-
ning Tree algorithm from controlling VLAN ports, leaving active ports
in a forwarding state. Configured through the
VLAN Spanning Tree status for the VLAN in the flat mode: on
(enabled) allows the Spanning Tree algorithm to determine the state of
VLAN ports (forwarding or blocking); off (disabled) prevents Span-
ning Tree algorithm from controlling VLAN ports, leaving active ports
in a forwarding state. Configured through the
VLAN Authentication status: on (enabled) or off (disabled). Note that
this status is always off because configuring authenticated VLANs is
not supported.
IP router interface status: on (IP interface exists for the VLAN) or off
(no IP router interface exists for the VLAN). Use the
mand to define an IP router interface for a VLAN.
Mobile tagging status: on (enabled); off (disabled). Configured through
the vlan mobile-tag
Source learning status: on (enabled) ; off (disabled). Configured
through the vlan source-learning
The user-defined text description for the VLAN. By default, the VLAN
ID is specified for the VLAN description.
Type of traffic passing through the VLAN. For example, customer traf-
fic tunneled through a VLAN Stacking Ethernet Service VLAN
(SVLAN). Note this VLAN Stacking is supported only on Metro
switches.
Priority map value set for the VLAN.
November 2009
vlan command to create or remove
command.
command.
vlan
vlan stp command.
vlan stp command.
ip interface com-
page 22-13