Lacp Agg Partner Admin Port - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

lacp agg partner admin port

Configures the administrative status of a partner port.
lacp agg [ethernet | fastethernet | gigaethernet] slot/port partner admin port partner_admin_port
lacp agg [ethernet | fastethernet | gigaethernet] slot/port
no partner admin port
Syntax Definitions
ethernet
fastethernet
gigaethernet
slot
port
partner_admin_port
Defaults
parameter
partner_admin_port
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use the no form of this command to remove a partner_admin_port value from a slot and port associ-
ated with a dynamic aggregate group.
•
The ethernet, fastethernet, and gigaethernet keywords do not modify a port's configuration. See
Chapter 20, "Ethernet Port Commands,"
Examples
-> lacp agg 2/1 partner admin port 255
-> lacp agg 2/1 no partner admin port
Release History
Release 6.6.1; command was introduced.
page 12-40
Documents that the port is 10 Mbps Ethernet.
Documents that the port is 100 Mbps Fast Ethernet.
Documents that the port is Gigabit Ethernet.
The slot number for this aggregate.
The port that the switch will initially use as the Spanning Tree virtual
port for this aggregate.
The administrative state of the partner port. Possible values are
0–65535.
default
0
for information on CLI commands to configure Ethernet ports.
OmniSwitch 6250 CLI Reference Guide
Link Aggregation Commands
November 2009