Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual page 887

Hide thumbs Also See for OmniSwitch 6250:

Table of Contents

VLAN Stacking Commands

Usage Guidelines

Use the no form of this command to delete a UNI profile.

Remove any UNI profile associations with UNI ports before attempting to modify or delete the profile.

Up to five unique UNI profile combinations, including the default profile, are allowed per switch. If a

profile has the same processing settings as any other profile, the profile is not considered unique.

Not all of the protocol parameters are currently supported with the peer, tunnel, and discard parame-

ters. Use the following table to determine the parameter combinations that are supported:

Note that the VLAN Stacking provider edge (PE) switch will not tunnel GVRP frames unless the

GVRP feature and/or GVRP transparent switching functionality is enabled on the PE switch. This is

true even if GVRP processing is enabled for the VLAN Stacking port.

If a user-configured UNI profile is not associated with a UNI port, then the default profile (default-uni-

profile) is used to process control packets ingressing on the port.

-> ethernet-service uni-profile uni_1 l2-protocol stp gvrp discard

-> no ethernet-service uni-profile uni_1

Release History

Release 6.6.1; command was introduced.

Related Commands

ethernet-service uni uni-profile

ethernet-service sap uni

show ethernet-service uni

show ethernet-service uni-

alaEServiceUNIProfileTable

alaEServiceUNIProfileID

alaEServiceUNIProfileStpBpduTreatment

alaEServiceUNIProfile8021xTreatment

OmniSwitch CLI Reference Guide

Associates a VLAN Stacking UNI profile with a UNI port.

Configures the switch port as a VLAN Stacking UNI and associates the

port with a VLAN Stacking Service Access Point (SAP).

Displays the profile associations for VLAN Stacking UNI ports.

Displays the profile attribute configuration for VLAN Stacking UNI

November 2009