Show Interfaces Hybrid Status - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

Ethernet Port Commands

show interfaces hybrid status

Displays interface line settings (e.g., speed, mode) for combo ports only.
show interfaces [slot[/port[-port2]]] hybrid {fiber |copper} status
Syntax Definitions
slot
port
port2
fiber
copper
Defaults
If a specific slot or slot/port number is not entered with this command, the status and configuration
configuration for all switch combo ports is displayed..
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use the slot, slot/port, or slot/port-port2 parameters to display the status and configuration for all ports
on a slot, a specific port, or a range of ports.
•
The hybrid mode for combo ports is not configurable; combo ports are set to preferred fiber by default.
As a result, the Hybrid Mode field always displays preferred fiber (PF) for all combo ports.
Examples
-> show interfaces hybrid fiber status
Slot/ AutoNego
Port (Mbps)
-----+--------+------+------+------+--------+------+------+------
1/25 Enable
1/26 Enable
FF - ForcedFiber PF - PreferredFiber
FC - ForcedCopper PC - PreferredCopper C - Copper
output definitions
Slot/Port
AutoNego
Detected Speed
OmniSwitch 6250 CLI Reference Guide
Slot number you want to display.
Port number of the interface you want to display.
Last port number in a range of ports you want to display.
Specifies that the status of the SFP port(s) will be displayed.
Specifies that the status of the copper RJ-45 port(s) will be displayed.
DETECTED
Speed Duplex Hybrid
Type
- - -
- - -
Interface slot/port number.
Autonegotiation status (Enable/Disable).
Detected line speed (10/100/Auto/1000/10000 Mbps).
November 2009
CONFIGURED
Speed Duplex Hybrid
(Mbps) Mode
1000 Full PF
1000 Full PF
F - Fiber
Trap
LinkUpDown
-
-
page 20-71