Ethoam Association Endpoint-List - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

Ethernet OAM Commands

ethoam association endpoint-list

Modifies the MEP list of an Ethernet OAM Maintenance Association.
ethoam association association_name domain {domain_name | mac_address}
endpoint-list mep_id[-mep_id2]
no ethoam association association_name domain {domain_name | mac_address}
endpoint-list mep_id[-mep_id2]
Syntax Definitions
association_name
domain_name
mac_address
mep_id
mep_id2
Defaults
N/A
Platforms Supported
OmniSwitch 6250-Metro Models
Usage Guidelines
•
Use the no form of this command to remove the MEP list.
•
Note that only the MEP that is associated with the MEP list of the MA can be configured locally on the
bridge or monitored remotely.
•
The association_name should be unique within a domain.
Examples
-> ethoam association alcatel-sales domain esd.alcatel-lucent.com endpoint-list
100-200
-> no ethoam association alcatel-sales domain esd.alcatel-lucent.com endpoint-list
100-200
Release History
Release 6.6.1; command was introduced.
OmniSwitch 6250 CLI Reference Guide
Name of the Ethernet OAM Association. Up to 48 (minus domain name
length) characters may be used.
Specifies the domain name. For more information on the different
formats of the domain name, refer to
page 25-3.
Specifies the CFM system MAC address.
Specifies the MEP number.
Last MEP number in a range of MEPs you want to configure.
November 2009
ethoam domain command on
page 25-13