Ethernet-Service Source-Learning - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

ethernet-service source-learning

Configures the status of source learning on a VLAN Stacking VLAN (SVLAN) used for tunneling
customer traffic or on an SVLAN that the IP Multicast VLAN (IPMV) application uses to
distribute multicast network traffic.
ethernet-service {svlan | ipmvlan} svid1[-svid2] source-learning {enable| disable}
Syntax Definitions
svlan
ipmvlan
svid1
-svid2
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 6250-Metro Models
Usage Guidelines
•
By default, source MAC address learning is enabled on all the SVLANs.
•
Disabling source learning on an SVLAN clears all the dynamically learned MAC addresses associated
with the VLAN from the MAC address table.
•
Static MAC addresses associated with an SVLAN are not cleared when source learning is disabled for
the SVLAN.
•
Configuring the source learning status is not supported on Management SVLANs.
Examples
-> ethernet-service svlan 120-150 source-learning disable
-> ethernet-service ipmvlan 320-350 source-learning disable
Release History
Release 6.6.1; command was introduced.
page 24-4
Specifies an SVLAN for tunneling customer traffic.
Specifies an SVLAN used by IP Multicast VLAN to distribute
multicast traffic.
The VLAN ID number identifying the SVLAN (2–4094).
The last VLAN ID number in a range of SVLANs that you want to
configure (e.g. 10-12 specifies SVLANs 10, 11, and 12).
Enables source MAC address learning.
Disables source MAC address learning.
default
enable
OmniSwitch CLI Reference Guide
VLAN Stacking Commands
November 2009