Show Vlan Port - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

VLAN Management Commands

show vlan port

Displays VLAN port associations (VPAs) for all VLANs, a specific VLAN, or for a specific port. Infor-
mation is also included that shows the VPA type (configured default VLAN, 802.1Q tagged VLAN,
dynamically assigned secondary VLAN, or mirrored port VLAN assignment) and the status of that associ-
ation (inactive, blocking, forwarding, or filtering).
show vlan [vid] port [slot/port | link_agg]
Syntax Definitions
vid
slot/port
ling_agg
Defaults
If no parameters are specified with this command, a list of all VLANs and their assigned ports is displayed
by default.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
If the vid is specified without a slot/port or link_agg, then all port assignments for that VLAN are
displayed.
•
If the slot/port or link_agg is specified without a vid, then all VLAN assignments for that port are
displayed.
•
If both the vid and slot/port or link_agg are specified, then information only for that VLAN and slot/
port or link aggregate ID is displayed.
•
Note that specifying a range of VLAN IDs is also allowed. Use a hyphen to indicate a contiguous
range (e.g., show vlan 10-15 port). Note that only one VLAN entry—a single VLAN ID or a range of
VLAN IDs— is allowed with this command. Multiple entries are not accepted.
Examples
-> show vlan port
vlan port
+-----+-------+---------+------------+
1 1/1
2 1/2
1/3
11/4
3 1/2
11/4
2/5
OmniSwitch 6250 CLI Reference Guide
VLAN ID number (1–4094).
Enter the slot number for the module and the physical port number on
that module (e.g. 3/1 specifies port 1 on slot 3).
Enter the link aggregate ID number (0–31) to assign to the specified
VLAN.
type status
default inactive
default blocking
mobile forwarding
qtagged forwarding
qtagged blocking
default forwarding
dynamic forwarding
November 2009 page 22-15