Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual page 816

-> show vlan 10 port
port type
+------+--------+------------+
1/1 default
1/2 qtagged
1/3 mobile
-> show vlan port 3/2
vlan type
+------+---------+------------+
1 default
2 qtagged
5 dynamic
3 qtagged
-> show vlan 500 port 8/16
type :default
status :blocking
vlan admin :on
vlan oper :off
port admin :on
port oper :off
output definitions
vlan
port
type
status
vlan admin
vlan oper
page 22-16
status
forwarding
forwarding
forwarding
status
forwarding
forwarding
blocking
blocking
Numerical VLAN ID. Identifies the port's VLAN assignment.
The slot number for the module and the physical port number on that
module (e.g. 3/1 specifies port 1 on slot 3).
The type of VPA: default (configured default VLAN assignment for
the port), qtagged (802.1Q tagged secondary VLAN assignment for the
port), mobile (dynamic secondary VLAN assignment for the port),
mirror (port is mirroring the VLAN assignment of another port), or
dynamic (VPAs that are learnt through GVRP).
The VPA status: inactive (port is not active), forwarding (traffic is for-
warding on this VPA), blocking (traffic is not forwarding on this VPA),
or filtering (a mobile port's VLAN is administratively off or the port's
default VLAN status is disabled; does not apply to fixed ports).
VLAN administrative status: on enables VLAN functions to operate;
off disables VLAN functions without deleting the VLAN. Use the
command to change the VLAN administrative status.
VLAN operational status: on (enabled) or off (disabled). The opera-
tional status remains disabled until an active port is assigned to the
VLAN. When the operational status is enabled, then VLAN properties
(e.g. router interfaces, Spanning Tree) are applied to ports and traffic
flow. A VLAN must have an enabled administrative status before it can
become operationally enabled.
OmniSwitch 6250 CLI Reference Guide
VLAN Management Commands
November 2009
vlan