Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual page 360

partner_admin_port
partner_admin_port_priority
Defaults
parameter
[active] [timeout] ....
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use the no form of this command to remove a slot and port from a dynamic aggregate group.
•
Mobile ports cannot be aggregated.
•
A port may belong to only one aggregate group.
•
Ports in a dynamic aggregate must all be in the same speed (e.g., all 100 Mbps. 1 Gigabit. or all 10
Gigabit).
•
Ports that belong to the same dynamic aggregate group do not have to be configured sequentially and
can be on any Network Interface (NI).
•
The ethernet, fastethernet, and gigaethernet keywords do not modify a port's configuration. See
Chapter 20, "Ethernet Port Commands,"
Examples
-> lacp agg 3/1 actor admin key 0
-> lacp agg no 3/1
Release History
Release 6.6.1; command was introduced.
Related Commands
lacp linkagg size
show linkagg port
MIB Objects
alclnkaggAggPortTable
alclnkaggAggPortGlobalPortNumber
alclnkaggAggActorAdminKey
alclnkaggAggPortLacpType
alclnkaggAggPortActorAdminState
alclnkaggAggPortActorSystemID
page 12-22
The administrative state of the partner port. Possible values are
0–65535.
The priority of the partner port. Possible values are 0–255.
default
active, timeout, aggregate
for information on CLI commands to configure Ethernet ports.
Creates a dynamic aggregate group.
Displays information about ports associated with a particular aggregate
group or all aggregates.
OmniSwitch 6250 CLI Reference Guide
Link Aggregation Commands
November 2009