Loopback-Detection Port - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

Loopback Detection Commands

loopback-detection port

Enables or disables LBD on a specific port.
loopback-detection port slot/port [-port2] {enable | disable}
Syntax Definitions
slot/port
-port2
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 6250-Metro Models
Usage Guidelines
•
Loopback Detection must be enabled globally to enable LBD functionality on a specific port.
•
LBD can be configured for a port and the configuration can be applied and retained, whether or not
LBD is enabled globally. However, LBD functionality on a port is available only when LBD is enabled
globally on the switch.
Examples
-> loopback-detection port 1/1 enable
-> loopback-detection port 1/1-8 enable
Release History
Release 6.6.1; command was introduced.
OmniSwitch 6250 CLI Reference Guide
The slot number and the physical port number of the module that is
being configured for LBD.
Specifies the last port in the range of ports.
Enables LBD on the specified port.
Disables LBD on the specified port.
default
disable
November 2009 page 17-3