Ethernet-Service Statistics Reset - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

VLAN Stacking Commands

ethernet-service statistics reset

Resets the Tri-Color Marking (TCM) packet counters to zero. TCM ingress rate limiting/policing is
configured and applied using SAP profiles. Packets serviced by a TCM SAP are marked green, yellow, or
red. Statistics are kept as to the number of packets marked with each color. Use this command to clear
these statistics and restart the counting from zero.
ethernet-service statistics reset
Syntax Definitions
N/A.
Defaults
N/A.
Platforms Supported
OmniSwitch 6250-Metro Models
Usage Guidelines
•
Packet counts are reset to zero for all SAPs that use TCM parameters for ingress rate limiting. Clear-
ing the statistics for only one SAP is not allowed.
•
Use the show ethernet-service statistics command to display the current statistics for TCM packet
counts.
•
For more information about TCM, see the "Configuring QoS" chapter in the OmniSwitch 6250
Network Configuration Guide.
Examples
-> ethernet-service statistics reset
Release History
Release 6.6.1; command was introduced.
Related Commands
show ethernet-service statistics
show ethernet-service sap-
profile
MIB Objects
OmniSwitch CLI Reference Guide
Displays the TCM packet counts by service or for a specific SAP ID.
Displays the SAP profile configuration.
November 2009 page 24-23