Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual page 582

output definitions (continued)
Desig Cost
Role
Prim. Port
Op Cnx
Op Edg
Desig Bridge ID
-> show spantree 2 ports configured
Spanning Tree Port Admin Configuration for Vlan 2
Port Adm Man. Config
Port Pri St. Mode
-----+----+----+----+-------+----+----+----+----+----+---------+---------
3/1 7 ENA
3/3 7 ENA
0/9 7 ENA
output definitions
Port
Port Pri
Adm St
Man. Mode
Config Cost
Adm Cnx
Adm Edg
page 16-142
The path cost of the Designated Port of the segment connected to this
port. If this is the root bridge or the Spanning Tree status of the port is
administratively disabled, this value is 0.
The role of the port for this Spanning Tree instance. Possible port roles
are: root, designated, alternate, and backup.
The slot number for the module and the physical port number on that
module for the primary port associated with this Spanning Tree
instance. This information is only available if the port role is backup.
Operational connection type: PTP, NPT, or NS (nonsignificant).
Shows the current operational state of the port's connection type. See
the bridge slot/port connection
information.
Operational connection type: EDG. Shows the current operational state
of the port's connection type. See the
command on
The bridge identifier for the designated bridge for this port's segment.
Adm Adm
Cost Cnx Edg
No 0 AUT No
No 0 AUT No
No 0 AUT No
The slot number for the module and the physical port number or a logi-
cal port. If the slot number is 0, then the port number refers to a link
aggregate logical port number (e.g., 0/31).
The Spanning Tree priority for the port (0–15). The lower the number,
the higher the priority. Configured through the
ity command.
The Spanning Tree administrative status of the port: enabled or dis-
abled. Configured through the
disable Spanning Tree on a port.
The manual mode setting for the port: yes indicates that the blocking or
forwarding state of the port was manually set and the port does not par-
ticipate in the Spanning Tree Algorithm; no indicates that the Spanning
Tree Algorithm is managing the port state. Configured through the
bridge slot/port mode
The configured path cost value for this port. Configured through the
bridge slot/port path cost
The administrative connection type: PTP, NPT, or AUT. Configured
through the
The edge port administrative status: yes indicates that the port is an
admin edge port; no indicates that the port is not an admin edge port.
Configured through the
Distributed Spanning Tree Commands
command on
page 16-87 for more information.
Aut Rstr Rstr OS8800
Edg Tcn Role 10G Opt.
Yes No No DIS
Yes No No DIS
Yes No No DIS
bridge slot/port
command.
command.
bridge slot/port connection
bridge slot/port connection
OmniSwitch 6250 CLI Reference Guide
page 16-87 for more
bridge slot/port connection
PVST+
Cfg Stst
AUT/ON
AUT/OFF
AUT/ON
bridge slot/port prior-
command to enable or
command.
command.
November 2009