Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual page 593

Distributed Spanning Tree Commands
output definitions (continued)
Man. Mode
Config Cost
Adm Cnx
Adm Edg
Aut Edg
Rstr Tcn
Rstr Role
OS8800 10G Opt.
Release History
Release 6.6.1; command was introduced.
Related Commands
show spantree ports
show spantree cist ports
show spantree 1x1 ports
OmniSwitch 6250 CLI Reference Guide
The manual mode setting for the port: yes indicates that the blocking or
forwarding state of the port was manually set and the port does not par-
ticipate in the Spanning Tree Algorithm; no indicates that the Spanning
Tree Algorithm is managing the port state. Configured through the
bridge slot/port mode command.
The configured path cost value for this port. Configured through the
bridge msti slot/port path cost
The administrative connection type: PTP, NPT, or AUT. Configured
through the bridge slot/port connection
The edge port administrative status: yes indicates that the port is an
admin edge port; no indicates that the port is not an admin edge port.
Configured through the
The edge port automatic status: yes indicates that the port is an auto-
matic edge port; no indicates that the port is not an automatic edge port.
Configured through the
slot/port auto-edge command.
The restricted TCN capability: yes indicates that the port supports the
restricted TCN capability; no indicates that the port does not support
the restricted TCN capability. Configured through the
port restricted-tcn or bridge 1x1 slot/port restricted-tcn
The restricted role port status: yes indicates that the port is a restricted
role port; no indicates that the port is not a restricted role port. Config-
ured through the bridge cist slot/port restricted-role
slot/port restricted-role
N/A
Implicit command for displaying Spanning Tree port information
for the flat mode CIST instance or a 1x1 mode VLAN instance.
Explicit command for displaying Spanning Tree port information
for a CIST instance when the switch is operating in the 1x1 or flat
Spanning Tree mode.
Explicit command for displaying Spanning Tree port information
for a VLAN when the switch is operating in the 1x1 or flat Span-
ning Tree mode.
November 2009
command.
command.
bridge slot/port connection
bridge cist slot/port auto-edge
command.
command.
or bridge 1x1
bridge cist slot/
command.
or bridge 1x1
page 16-153