Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual page 583

Distributed Spanning Tree Commands
output definitions (continued)
Aut Edg
Rstr Tcn
Rstr Role
OS8800 10G Opt.
PVST+ Cfg
PVST+ Stat
Release History
Release 6.6.1; command was introduced.
Related Commands
show spantree cist ports
show spantree msti ports
show spantree 1x1 ports
OmniSwitch 6250 CLI Reference Guide
The edge port automatic status: yes indicates that the port is an auto-
matic edge port; no indicates that the port is not an automatic edge port.
Configured through the
slot/port auto-edge command.
The restricted TCN capability: yes indicates that the port supports the
restricted TCN capability; no indicates that the port does not support
the restricted TCN capability. Configured through the
port restricted-tcn or bridge 1x1 slot/port restricted-tcn
The restricted role port status: yes indicates that the port is a restricted
role port; no indicates that the port is not a restricted role port. Config-
ured through the bridge cist slot/port restricted-role
slot/port restricted-role
N/A
Indicates the current PVST+ port configuration (auto, enable or dis-
able).
Indicates the current status of the PVST+ port (On or Off).
Implicit command for displaying Spanning Tree port information
for the flat mode CIST when the switch is operating in the 1x1 or
flat Spanning Tree mode.
Explicit command for displaying Spanning Tree port information
for an MSTI when the switch is operating in the 1x1 or flat Span-
ning Tree mode.
Explicit command for displaying Spanning Tree port information
for a VLAN instance when the switch is operating in the 1x1 or flat
Spanning Tree mode.
November 2009
bridge cist slot/port auto-edge
command.
or bridge 1x1
bridge cist slot/
command.
or bridge 1x1
page 16-143