Show Linkagg - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

show linkagg

Displays information about static and dynamic (LACP) aggregate groups.
show linkagg [agg_num]
Syntax Definitions
agg_num
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
If no aggregation number is specified, information for all aggregate groups is displayed. If an aggre-
gate number is specified, information about that aggregate group is displayed only. The fields included
in the display depend on whether the aggregate group is a static or dynamic.
•
Use the show linkagg port command to display information about aggregate group ports.
Examples
No aggregate group is specified:
-> show linkagg
Number Aggregate
-------+----------+--------+----+-------------+-------------+-------------
1 Static
2 Dynamic
3 Dynamic
4 Dynamic
5 Static
Output fields are defined here:
output definitions
Number
Aggregate
SNMP Id
Size
page 12-44
Specifies the aggregate group. Configured through the static linkagg
size or lacp linkagg size command.
SNMP Id Size Admin State
40000001 8 ENABLED
40000002 4 ENABLED
40000003 8 ENABLED
40000004 8 ENABLED
40000005 2 DISABLED
The aggregate group number.
The type of aggregate group, which can be Static or Dynamic.
The SNMP ID associated with the aggregate group.
The number of links in this aggregate group.
Oper State
UP
DOWN
DOWN
UP
DOWN
OmniSwitch 6250 CLI Reference Guide
Link Aggregation Commands
Att/Sel Ports
2 2
0 0
0 2
3 3
0 0
November 2009