SROS Command Line Interface Reference Guide
ip rip send version [1 | 2]
Use the ip rip send version command to configure the RIP version the unit sends in all RIP packets
transmitted on the interface. Use the no form of this command to restore the default value.
Syntax Description
1
2
Default Values
By default, all interfaces transmit RIP version 1 (the default value for the version command).
Functional Notes
Use the ip rip send version command to specify a RIP version that overrides the version (in the Router
RIP) configuration. See
The SROS only transmits one version (either 1 or 2) on a given interface.
Usage Examples
The following example configures the HDLC interface to transmit only RIP version 2 packets:
ProCurve(config)#interface hdlc 1
ProCurve(config-hdlc 1)#ip rip send version 2
5991-2114
Only transmits RIP version 1 packets on the interface.
Only transmits RIP version 2 packets on the interface.
version [1 l 2]
on page 1390 for more information.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
HDLC Command Set
1018