HP ProCurve 7102dl Reference Manual page 1023

SROS Command Line Interface Reference Guide
ip unnumbered <interface>
Use the ip unnumbered command to use the IP address assigned to the specified interface for all IP
processing on the active interface. Use the no form of this command to remove the unnumbered
configuration.
Syntax Description
<interface>
Default Values
By default, all interfaces are configured to use a specified IP address (using the ip address command).
Functional Notes
If ip unnumbered is enabled on an interface, all IP traffic from the interface will use a source IP address
taken from the specified interface. For example, specifying ip unnumbered eth 0/1 while in the Frame
Relay Sub-Interface Configuration mode configures the Frame Relay sub-interface to use the IP address
assigned to the Ethernet interface for all IP processing. In addition, the SROS uses the specified interface
information when sending route updates over the unnumbered interface.
Usage Examples
The following example configures the HDLC interface to use the IP address assigned to the Ethernet
interface (eth 0/1):
ProCurve(config)#interface hdlc 1
ProCurve(config-hdlc 1)#ip unnumbered eth 0/1
5991-2114
Specifies the interface in the format type slot/port (e.g., ppp 1) that contains the
IP address to be used as the source address for all packets transmitted on this
interface.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
HDLC Command Set
1021