Storm-Control Multicast (Interface); Storm-Control Unknown-Unicast (Configuration) - Dell Z9500 Reference Manual

some multicast control traffic may get dropped when storm control thresholds are
exceeded.

storm-control multicast (Interface)

Configure the percentage of multicast traffic allowed on an C-Series or S-Series interface (ingress only)
network only.
Z9500
Syntax
storm-control multicast packets_per_second in
To disable multicast storm control on the interface, use the no storm-control
multicast packets_per_second in command.
Parameters
packets_per_se
cond in
Defaults none
Command INTERFACE (conf-if-interface-slot/port)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0

storm-control unknown-unicast (Configuration)

Configure the percentage of unknown-unicast traffic allowed in or out of the network.
Z9500
Syntax
storm-control unknown-unicast [packets_per_second in]
Storm Control
Enter the packets per second of broadcast traffic allowed
into the network. The range is from 0 to 33554368.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-series and S-Series.
1715