Show Multicast Interface - Dell PowerConnect J-EX4200-24T Software Manual

show multicast interface

Syntax
Syntax (J-EX Series
Switch)
Release Information
Description
Options
Required Privilege
Level
List of Sample Output
Output Fields
Chapter 80: Operational Mode Commands for IGMP Snooping and Multicast
show multicast interface
<logical-system (all | logical-system-name)>
show multicast interface
Command introduced before Junos OS Release 10.2 for J-EX Series switches.
Display bandwidth information about IP multicast interfaces.
—Display all interfaces that have multicast configured.
none
logical-system (all | logical-system-name)
systems or on a particular logical system.
view
show multicast interface on page 2192
Table 271 on page 2191 describes the output fields for the
command. Output fields are listed in the approximate order in which they appear.
Table 271: show multicast interface Output Fields
Field Name
Interface
Maximum bandwidth (bps)
Remaining bandwidth (bps)
Mapped bandwidth
deduction (bps)
Local bandwidth deduction
(bps)
—(Optional) Perform this operation on all logical
Field Description
Name of the multicast interface.
Maximum bandwidth setting, in bits per second, for this interface.
Amount of bandwidth, in bits per second, remaining on the interface.
Amount of bandwidth, in bits per second, used by any flows that
are mapped to the interface.
NOTE: Adding the mapped bandwidth deduction value to the local
bandwidth deduction value results in the total deduction value for
the interface.
This field does not appear in the output when the no QoS
adjustment feature is disabled.
Amount of bandwidth, in bits per second, used by any mapped flows
that are traversing the interface.
NOTE: Adding the mapped bandwidth deduction value to the local
bandwidth deduction value results in the total deduction value for
the interface.
This field does not appear in the output when the no QoS
adjustment feature is disabled.
show multicast interface
2191