Storm-Control Multicast (Interface) - Dell S6000 Reference Manual

storm-control multicast (Interface)

Configure the percentage of multicast traffic allowed on an C-Series or S-Series interface (ingress only)
network only.
S6000
Syntax
storm-control multicast packets_per_second in
To disable multicast storm control on the interface, use the no storm-control
multicast packets_per_second in command.
Parameters
packets_per_se
cond in
Defaults none
Command INTERFACE (conf-if-interface-slot/port)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
storm-control unknown-unicast (Configuration)
Configure the percentage of unknown-unicast traffic allowed in or out of the network.
S6000
Syntax
storm-control unknown-unicast [packets_per_second in]
To disable storm control for unknown-unicast traffic, use the no storm-control
unknown-unicast [packets_per_second in] command.
Parameters
packets_per_se
cond in
1392
Enter the packets per second of broadcast traffic allowed
into the network. The range is from 0 to 33554368.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-series and S-Series.
Enter the packets per second of broadcast traffic allowed
into the network. The range is from 0 to 33554368.
Storm Control