Vrrp Delay Minimum - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

Version 7.4.1.0

The VRRP group only becomes active and sends VRRP packets when a virtual IP

address is configured. When you delete the virtual address, the VRRP group stops

sending VRRP packets.

A system message appears after you enter or delete the virtual-address

To guarantee that a VRRP group becomes MASTER, configure the VRRP group's

virtual address with the same IP address as the interface's primary IP address and

change the priority of the VRRP group to 255.

You can ping the virtual addresses configured in all VRRP groups.

vrrp delay minimum

Set the delay time for VRRP initialization after an interface comes up.

vrrp delay minimum seconds

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

Version 9.0.0.0

Version 8.3.8.0

Introduced support for telnetting to the VRRP group IP

address assigned using this command.

Introduced on the E-Series.

Enter the number of seconds for the delay for VRRP

initialization after an interface becomes operational. The

range is from 0 to 900 (0 indicates no delay).

Introduced on the S6000.

Introduced on the Z9000.

Introduced on the S4820T.

Introduced on the S4810.

Virtual Router Redundancy Protocol (VRRP)