Debug Dcbx - Dell S4810 Reference Manual

Configure DCBX operation at the INTERFACE level on a switch or globally on the
switch. To verify the DCBX configuration on a port, use the show interface
dcbx detail command.

debug dcbx

Enable DCBX debugging.
S4810
Syntax
debug dcbx {all | auto-detect-timer | config-exchng | fail |
mgmt | resource | sem | tlv}
To disable DCBX debugging, use the no debug dcbx command.
Parameters
{all | auto-
detect-timer |
config-exchng
| fail | mgmt |
resource | sem
| tlv}
Defaults none
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version
8.3.12.0
Version
8.3.16.0
558
Enter the type of debugging, where:
• all: enables all DCBX debugging operations.
• auto-detect-timer: enables traces for DCBX auto-
detect timers.
• config-exchng: enables traces for DCBX configuration
exchanges.
• fail: enables traces for DCBX failures.
• mgmt: enables traces for DCBX management frames.
• resource: enables traces for DCBX system resource
frames.
• sem: enables traces for the DCBX state machine.
• tlv: enables traces for DCBX TLVs.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.
Data Center Bridging (DCB)