Clear Ets Counters - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

configured bandwidth allocation is ignored for priority-group traffic when you

apply the output policy on an interface.

By default, equal bandwidth is assigned to each priority group in the ETS output

policy applied to an egress port if you did not configure bandwidth allocation. The

sum of configured bandwidth allocation to dot1p priority traffic in all ETS priority

groups must be 100%. Allocate at least 1% of the total bandwidth to each priority

group and queue. If bandwidth is assigned to some priority groups but not to

others, the remaining bandwidth (100% minus assigned bandwidth amount) is

equally distributed to nonstrict-priority groups which have no configured

clear ets counters

Clear all ETS TLV counters on an interface.

clear ets counters port-type slot/port

EXEC Privilege

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

qos-policy-output ets

— creates a QoS output policy.

— schedules priority traffic in port queues.

Enter the keywords port-type then the slot/port

information.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the S4810.

Introduced on the MXL 10/40GbE Switch IO Module.

Data Center Bridging (DCB)