Description - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

To remove only the DCB output policies applied to the specified switch, use the no

dcb-policy output stack-unit command.

stack-unit-id

CONFIGURATION

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

The dcb-policy output stack-unit all command overwrites any previous

dcb-policy output stack-unit stack-unit-id configurations. Similarly, a

dcb-policy output stack-unit stack-unit-id command overwrites any

previous dcb-policy output stack-unit all configuration.

You can apply a DCB output policy with ETS configuration to all stacked ports in a

switch stack or an individual stacked switch. You can apply different DCB output

policies to different stack units.

dcb-policy input stack-unit stack-ports all

description

Enter a text description of the DCB policy (PFC input or ETS output).

description text

Enter the stack unit identification.

Enter the policy name for the DCB output policy.

Introduced on the S4820T.

Introduced on the S4810.

Introduced on the MXL 10/40GbE Switch IO Module.

NOTE: Please note that Dell Networking does not recommended to use this

command as it has been deprecated in the current 9.4.(0.0) release. A warning

message appears when you try to run this command indicating that you have

to use the dcb-map commands in the future.

— applies the specified DCB input

Data Center Bridging (DCB)