Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual page 2332

802.1AB Commands
lldp transmit interval seconds
lldp transmit hold-multiplier num
lldp transmit delay seconds
lldp reinit delay seconds
lldp notification interval seconds
lldp {port slot/port [-port ]| slot slot | chassis} lldpdu {tx | rx | tx-and-rx | disable}
lldp {port slot/port[-port ] | slot slot | chassis} notification {enable | disable}
lldp {port slot/port [-port ] | slot slot | chassis} tlv management {port-description | system-
name | system-description | system-capabilities | management-address} {enable |
disable}
lldp {port slot/port [-port ] | slot slot | chassis} tlv dot1 {port-vlan | vlan-name} {enable |
disable}
lldp {port slot/port [-port ]| slot slot | chassis} tlv dot3 mac-phy {enable | disable}
lldp {port slot/port [-port ] | slot slot | chassis} tlv med {power | capability} {enable | disable}
show lldp system-statistics
show lldp [port slot/port [-port ]] statistics
show lldp local-system
show lldp [port slot/port [-port ]| slot slot] local-port
show lldp local-management-address
show lldp [port slot/port [-port ] | slot slot] remote-system
show lldp { slot | slot/port [-port ]} config
slot
show lldp [port slot/port [-port ]
show lldp [slot/port [-port ] | slot] remote-system [med {network-policy | inventory}]
IP Commands
ip interface {name | emp} [{address | vip-address} ip_address] [mask subnet_mask] [admin-
state [enable | disable]] [vlan vlan_id] [forward | no forward] [local-proxy-arp | no local-
proxy-arp] [e2 | snap] [primary | no primary]
no ip interface name
ip interface name tunnel [source ip_address] [destination ip_address] [protocol {ipip | gre}]
ip router primary-address ip_address
ip router router-id ip_address
ip static-route ip_address [mask mask] gateway gateway|follows ip_address [metric metric]
no ip static-route ip_address [mask mask] gateway ip_address|follows ip_address [metric
metric]
ip route-pref {static | ospf | rip | ebgp | ibgp} value
ip default-ttl hops
ping {ip_address | hostname} [source-interface ip_interface] [count count] [size packet_size]
[interval seconds] [timeout seconds] [data-pattern string] [dont-fragment] [tos tos_val]
OmniSwitch CLI Reference Guide
slot] statistics
March 2011
traceroute {ip_address | hostname} [max-hop max_hop_count] [min-hop min_hop_count]
[source-interface ip_interface] [probes probe_count] [timeout seconds] [port
port_number_value]
ip directed-broadcast {on | off}
ip service {all | service_name | port service_port} admin-state {enable | disable}
ip service {service_name} port {default | service_port}
ip redist {local | static | rip | ospf | isis | bgp} into {rip | ospf | isis | bgp} route-map route-map-
name [status {enable | disable}]
no ip redist {local | static | rip | ospf | isis | bgp} into {rip | ospf | bgp} [route-map route-map-
name]
ip access-list access-list-name
no ip access-list access-list-name
ip access-list access-list-name
[redist-control {all-subnets | no-subnets | aggregate}]
no ip access-list access-list-name
ip route-map route-map-name [sequence-number number] match ip-nexthop
{access-list-name | ip_address/prefixLen
no ip route-map route-map-name [sequence-number number] match ip-nexthop
{access-list-name | ip_address/prefixLen
ip route-map route-map-name [sequence-number number] match ipv6-nexthop
{access-list-name | ipv6_address/prefixLen [permit | deny]}
no ip route-map route-map-name [sequence-number number] match ipv6-nexthop
{access-list-name | ipv6_address/prefixLen [permit | deny]}
ip route-map route-map-name [sequence-number number] match ipv4-interface interface-
name
no ip route-map route-map-name [sequence-number number] match ipv4-interface interface-
name
ip route-map route-map-name [sequence-number number] match ipv6-interface interface-
name
no ip route-map route-map-name [sequence-number number] match ipv6-interface interface-
name
ip route-map route-map-name [sequence-number number] match metric metric [deviation
deviation]
no ip route-map route-map-name [sequence-number number] match metric metric
[deviation deviation]
ip route-map route-map-name [sequence-number number] match route-type {
external [type1 | type2] | level1 | level2
no ip route-map route-map-name [sequence-number number] match route-type {
external [type1 | type2] | level1 | level2
ip route-map route-map-name [sequence-number number] set metric metric
[effect {add | subtract | replace | none}]
no ip route-map route-map-name [sequence-number number] set metric metric
[effect {add | subtract | replace | none}]
page 4
address [action {permit | deny}]
address/prefixLen
address
address/prefixLen
[permit | deny]}
[permit | deny]}
}
}
802.1AB Commands
internal |
internal |