Configure Log Target Severity - Extreme Networks ExtremeWare Command Reference Manual

Commands for Status Monitoring and Statistics

configure log target severity

configure log target [console-display | memory-buffer | nvram | session |
syslog [<host name/ip> {: <udp-port>} [local0 ... local7]]] {severity
<severity> {only}}
Description
Sets the severity level of messages sent to the target.
Syntax Description
console-display Specifies the console display.
memory-buffer Specifies the switch memory buffer.
nvram Specifies the switch NVRAM.
session Specifies the current session (including console display).
syslog Specifies a syslog target.
host name/ip Specifies the syslog host name or IP address.
udp-port Specifies the UDP port number for the syslog target.
local0... local7 Specifies the local syslog facility.
severity Specifies the least severe level to send (if the keyword only is omitted).
only Specifies that only the specified severity level is to be sent.
Default
By default, targets are sent messages of the following severity level and above:
• console display—info
• memory buffer—debug-data
• NVRAM—warning
• session—info
• syslog—debug-data
Usage Guidelines
This command configures the specified target with a severity level. The filter associated with the target
is not affected. A message is sent to a target if the target has been enabled, the message passes the
associated filter, the message is at least as severe as the configured severity level, and the message
output matches the regular expression specified.
See the command on page 775 for a detailed description of severity levels.
show log
To see the current configuration of a target, use the following command:
show log configuration target
To see the current configuration of a filter, use the following command:
show log configuration filter
694 ExtremeWare 7.5 Command Reference Guide