Enable Inline-Power Ports - Extreme Networks ExtremeWare Command Reference Manual

Power Over Ethernet Commands—Summit 300 and 400-24p Switches and Alpine PoE Module

enable inline-power ports

For the Alpine series I/O modules:
enable inline-power [ports all | <portlist>]
For the Summit 300-48 switch:
enable inline-power ports <portlist>]
Description
Enables power provided by all system ports or specified ports.
NOTE
This command is available only for the Alpine FM-32Pi PoE Module and the Summit 300-48 switch.
Syntax Description
ports all Enables power on all system ports. Applies only to Alpine series I/O modules.
portlist Specifies one or more slots and ports on which power will be enabled. May be in the form 2:*, 2:5,
2:6-2:8.
Default
Enable
Usage Guidelines
You can control whether inline power is provided by all system ports or specified ports by using the
disable inline-power [ports all | <portlist>]
<portlist>] command. Using the
available to all system ports or specified ports. Using the
command shuts down power currently provided by all system ports or specified ports. The system
defaults to enabling power on all 10/100 ports.
To power any port, the following conditions must exist:
• The system must be enabled for power.
• The slot must be enabled for power.
• The ports must be enabled for power.
Disabling a port providing power to a powered device (PD) immediately removes power to the PD.
Example
The following command enables power currently provided by port 2 on slot 3:
enable inline-power 3:2
2306
command and the
enable inline-power [ports all | <portlist>]
enable inline-power [ports all |
command makes power
disable inline-power [ports all | <portlist>]
ExtremeWare 7.5 Command Reference Guide