Configure Sharing Address-Based - Extreme Networks ExtremeWare Command Reference Manual

Hide thumbs Also See for ExtremeWare:

Table of Contents

configure sharing address-based

For "i" series switches:

configure sharing address-based [L2 | L2_L3 | L2_L3_L4]

For "e" series switches:

configure sharing address-based [ip-dest| ip-source| ip-source-dest

|mac-dest | mac-source | mac-source-dest]

Configures the part of the packet examined by the switch when selecting the egress port for

transmitting load-sharing data.

Syntax Description

ip-source-dest

mac-source-dest

Usage Guidelines

This feature is available using the address-based load-sharing algorithm only. The address-based

load-sharing algorithm uses addressing information to determine which physical port in the

load-sharing group to use for forwarding traffic out of the switch. Addressing information is based on

the packet protocol, as follows:

• IP packets—Uses the source and destination MAC and IP address, and the TCP port number.

ExtremeWare 7.5 Command Reference Guide

Indicates that the switch should examine the MAC source and destination address.

NOTE: This option is only available on "i" series switches.

Indicates that the switch should examine the MAC and IP source and destination address.

NOTE: This option is only available on "i" series switches.

Indicates that the switch should examine the MAC and IP address, and the UDP or TCP

well-know port number.

NOTE: This option is only available on "i" series switches.

Indicates that the switch should examine the IP destination address.