Table of Contents
Advertisement
The Building Wizard contains a list of floors ordered by floor number. A green circle next to a floor
specifies that the floor has been properly formatted using the Format Floor Wizard. Selecting the floor
causes the Edit Floor button to display. See
"Editing Floors in an Existing Building Model" on page 181
for further details.
A yellow circle next to a floor specifies that the floor is empty and has not yet been formatted. Selecting
the floor causes the Format Floor button to display. See
"Formatting Floors Using the Floor Formatting
Wizard" on page 169
for further details.
Add Floor
Use the Add Floor button on the Building Wizard dialog box to append a new unformatted floor to the
end of the list of floors for the current project workspace.
Remove Floor
Use the Remove Floor button on the Building Wizard dialog box to remove the currently selected
building floor from the list. Using this option will permanently delete the highlighted building floor and
will reorder the remaining floors. For example, if you select Floor 2 from a list of three floors and press
the Remove Floor button, Floor 2 will be completely removed (regardless of whether it has been
formatted or not) and floor 3 will be renamed to Floor 2 automatically.
Up/Down
Use the Up and Down buttons to move the currently selected floor up or down in the list of floors. The
first floor in the list will become the ground floor when the building is assembled, and the other floors
in the list will be assembled in the order they are listed (one on top of the other).
Format Floor
See
"Editing Floors in an Existing Building Model" on page 181
for details of each Edit (Format) Floor
option.
Help Button
Use the Help button on the Building Wizard dialog box to launch the Summit WMScanner User's Guide.
Assemble Building
Use the Assemble Building button to combine formatted floors into a single drawing that can be used by
Summit WMScanner to perform cross floor system performance analysis.The Building Wizard is
intended to guide you through the process of formatting and assembling the building floors Pressing
the Assemble Building button will overwrite your <workspace name>_Final.dwg file and delete all
placed access points. If you should need to make changes to your final assembled drawing (add or
delete walls, etc.), you may do so with the formatting menu commands directly available from the
Format Building menu instead of using the Building Floor Manager. See
"Editing Partitions and RF
Obstructions" on page 192
for details.
Summit WMScanner Users Guide
167
Advertisement
Table of Contents
