C28 Device Part Id (Partid) Register; C28 Revision Id (Revid) Register; C28 Device Part Id (Partid) Register Field Descriptions; C28 Revision Id (Revid) Register Field Descriptions - Texas Instruments Concerto F28M35 Series Technical Reference Manual

System Control Registers

1.13.2.12 C28 Device Part ID (PARTID) Register

15
PARTTYPE
LEGEND: R/W = Read/Write; R = Read only; -n = value after reset
Table 1-50. C28 Device Part ID (PARTID) Register Field Descriptions
Bit Field
15-8 PARTTYPE
7-0 PARTNO

1.13.2.13 C28 Revision ID (REVID) Register

15
LEGEND: R/W = Read/Write; R = Read only; -n = value after reset
Bit Field
15-0 REVID
182
System Control and Interrupts
Figure 1-39. C28 Device Part ID (PARTID) Register
R-0x0
Value Description
Device Part Type
These 8-bits are hard wired and indicate the device memory type
0x00 Flash Device
0xFF ROM Device
Device Part Number
These 8-bits specify the actual device part number. These bits are configured via OTP. On reset,
the M3 boot software will read the part number from the OTP and load it into the PARTNO field of
the DID1 register. This register field is a replica on the C28 side of the PARTNO bits of the DID1
register.
Figure 1-40. C28 Revision ID (REVID) Register
R-0x0 (first silicon rev)
Table 1-51. C28 Revision ID (REVID) Register Field Descriptions
Value Description
Silicon Revision Number
These 16-bits specify the silicon revision number for the particular part.
Copyright © 2012–2019, Texas Instruments Incorporated
8 7
REVID
SPRUH22I – April 2012 – Revised November 2019
www.ti.com
PARTNO
R
Submit Documentation Feedback
0
0