Front Tamper Move Failure Rap - Xerox WorkCentre 5687 Series Service Manual

11-005-130, 11-006-130, 11-310-130, 11-311-130 Front
Tamper Move Failure RAP
11-005-130 The front tamper fails to move to the front position.
11-006-130 The front tamper fails to move to the rear position.
11-310-130 The front tamper is not at the front home position.
11-311-130 The front tamper is not at the rear home position.
NOTE: The home position is the outermost position.
Initial Actions
• Figure 1, check for damage or obstructions that would prevent the front tamper assembly
from operating correctly. If necessary, install a new compiler carriage assembly, PL 11.46
Item 1.
• Jams can be caused if the tray settings do not match the paper in the trays. Make sure the
tray settings are correct.
Procedure
NOTE: All HCSS interlocks must be made to supply +24V to the motors.
Enter dC330, codes 11-005 tamper motor front move, then 11-003 tamper motor front home,
Figure 1. The front tamper moves between the inboard and home positions.
Y N
Go to Flag 2. Check the motor, MOT11-003.
Refer to:
• GP 10, How to Check a Motor.
• P/J404, Carriage PWB.
• 11C-130, HCSS Power Distribution RAP.
Install new components as necessary:
• Carriage PWB, PL 11.46 Item 5.
• Front tamper motor, PL 11.46 Item 10.
Enter dC330, code 11-310, actuate the front tamper home sensor, Figure 1 by using the
stacked codes, 11-003 and 11-005 to move the tamper. Observe the display. The
changes.
Y N
Go to Flag 1. Check the sensor, Q11-310.
Refer to:
• GP 11 How to Check a Sensor.
• P/J407, Carriage PWB.
• 11C-130, HCSS Power Distribution RAP.
Install new components as necessary:
• Carriage PWB, PL 11.46 Item 5.
• Compiler carriage assembly, PL 11.46 Item 1.
Go to Flag 3. Check the harness and connectors P/J412 and P/J432. Also check the harness
and connectors P/J401 and P/J428, refer to GP 7. The wiring and connectors are good.
Y N
Repair the wiring or install new components as necessary, PL 11.46.
A
WorkCentre 5687 Family
A
Perform SCP 6 Final Actions.
Compiler carriage assembly
display
Figure 1 Component location
August 2007
11-005-130, 11-006-130, 11-310-130, 11-311-130
2-375
Front tamper assembly
Front tamper home
sensor, Q11-310
Front tamper motor,
MOT 11-003
Status Indicator RAPs