Rear Tamper Move Failure Rap - Xerox WorkCentre 5687 Series Service Manual

11-007-130, 11-008-130, 11-312-130, 11-313-130 Rear
Tamper Move Failure RAP
11-007-130 The rear tamper fails to move to the front position.
11-008-130 The rear tamper fails to move to the rear position.
11-312-130 The rear tamper is not at the front home position.
11-313-130 The rear tamper is not at the rear home position.
NOTE: The home position is the outermost position.
Initial Actions
• Check for damage or obstructions that would prevent the tamper assembly from operating
correctly. If necessary, install a new compiler carriage assembly, PL 11.46 Item 1.
• Jams can be caused if the tray settings do not match the paper in the trays. Make sure the
tray settings are correct.
Procedure
NOTE: All HCSS interlocks must be made to supply +24V to the motors.
Enter dC330, codes 11-006 tamper motor rear move, then 11-004 tamper motor rear home,
Figure 1. The rear tamper moves between the inboard and home positions.
Y N
Go to Flag 2. Check the motor, MOT11-004.
Refer to:
• GP 10, How to Check a Motor.
• P/J402, Carriage PWB.
• 11C-130 HCSS Power Distribution RAP.
Install new components as necessary:
• Carriage PWB, PL 11.46 Item 5.
• Rear tamper motor, PL 11.46 Item 10.
Enter dC330, code 11-311, actuate the front tamper home sensor, Figure 1 by using the
stacked codes, 11-004 and 11-006 to move the tamper. Observe the display. The
changes.
Y N
Go to Flag 1. Check the sensor, Q11-311.
Refer to:
• GP 11 How to Check a Sensor.
• P/J407, Carriage PWB.
• 11C-130 HCSS Power Distribution RAP.
Install new components as necessary:
• Carriage PWB, PL 11.46 Item 5.
• Compiler carriage assembly, PL11.46/1.
Go to Flag 3. Check the harness and connectors P/J412 and P/J432. Also, check the harness
and connectors P/J401 and P/J428, refer to GP 7. The wiring and connectors are good.
Y N
Repair the wiring or install new components as necessary.
A
WorkCentre 5687 Family
A
Perform SCP 6 Final Actions.
Compiler carriage
assembly
display
Figure 1 Component location
August 2007
11-007-130, 11-008-130, 11-312-130, 11-313-130
2-377
Rear tamper home
sensor, Q11-311
Rear tamper motor,
MOT 11-004
Status Indicator RAPs