Toyota Tundra 2005 Service - Repair - Maintenance page 3503

Hide thumbs Also See for Tundra 2005:

Table of Contents

INTRODUCTION - Rivet Removal and Installation

_ T-Rivet with ø6.4 mm:

Do not place your hands or the wire harness within a radius

of 20 mm (0.70 in.) from the rivet, as the rivet is cut and

opened in this area.

_ Prizing a riveter damages the riveter showing that it is not

tightened correctly and bends the mandrel.

_ Loose tightening may result from either tilting the riveter

while handling or the riveter not connecting to the materi-

_ Loose tightening also occurs when a rivet is applied be-

tween materials without touching.

_ T-Rivet with ø6.4 mm:

When a mandrel of a rivet is lost, the rivet should be re-

placed to prevent loose tightening.