Toyota Tundra 2005 Service - Repair - Maintenance page 3496

Proper and Efficient Work Procedures
REMOVAL
PRE-REMOVAL MEASURING
Before removal or cutting
operations, take measurements
in accordance with the dimen-
sion diagram. Always use a
puller to straighten a damaged
body or frame.
PRECAUTIONS FOR DRILLING OR
CUTTING
Check behind any area to be drilled or
cut to insure that there are no hoses,
wires, etc., that may be damaged.
HINT: See "Handling Precautions on
Related Components" on page IN-6.
WRONG
INTRODUCTION - General Repair Instructions
NUMBER OF SPOT WELDS AND PANEL POSITIONS
The number of spot welds and the panel positions
to be removed are shown for your reference.
HINT: See "Symbols" on page IN-4,5.
REMOVAL OF ADJACENT COMPONENTS
When removing adjacent components,
apply protective tape to the surrounding
body and your tools to prevent damage.
HINT: See "Handling Precautions on
Related Components" on page IN-6.
CUTTING AREA
Always cut in a straight
line and avoid reinforced area.
Cutting Okay
Corners
Reinforcement
IN-11