Toyota Tundra 2005 Service - Repair - Maintenance page 3509

IN-10
Cutting Okay
Reinforcement
WRONG
INTRODUCTION
PROPER AND EFFICIENT WORK
PROCEDURES
1. REMOVAL
(a) PRE-REMOVAL MEASURING
(1) Before removal or cutting operations, take measure-
ments in accordance with the dimension diagram. Al-
ways use a puller to straighten a damaged body or
frame.
F10007
(b) CUTTING AREA
(1) Always cut in a straight line and avoid reinforced area.
Corners
F10008A
(c) PRECAUTIONS FOR DRILLING OR CUTTING
(1) Check behind any area to be drilled or cut to insure
that there are no hoses, wires, etc., that may be dam-
aged.
HINT: See "Handling Precautions on Related Compo-
nents" on page IN-15.
F10009A
(d) REMOVAL OF ADJACENT COMPONENTS
(1) When removing adjacent components, apply protec-
tive tape to the surrounding body and your tools to pre-
vent damage.
HINT: See "Handling Precautions on Related Compo-
nents" on page IN-15.
F10010