Toyota Tundra 2005 Service - Repair - Maintenance page 3500

Mandrel
Flange
øX mm
Rivet Size
Aluminum-Rivet
Before installation
After installation
Outer Inner
_ Small nonwaterproof
rivet
_ No magnetic
adherence
Aluminum-Rivet
Steel-Rivet
T-Rivet with ø6.4 mm
Aluminum-Rivet
with ø4.8 mm
Waterproof-Rivet
with ø4.8 mm
INTRODUCTION - Rivet Removal and Installation
RIVET REMOVAL AND INSTALLATION
PARTS NAME AND VARIETY OF RIVET
Steel-Rivet
Before installation
After installation
Outer Inner
_ Small nonwaterproof
rivet
_ Magnetic adherence
RIVET REMOVAL
1. SELECTION OF CUTTING TOOL
Cutting tool
Drill blade
Rivet size Blade size
ø4 mm ø4 mm
ø4.8 mm ø5 mm
ø6.4 mm ø6.5 mm
Rivet Cutter (P / N 09060-60350)
Waterproof-Rivet
Before installation
After installation
Waterproof Seal
Outer Inner
_ Small waterproof
rivet
_ Waterproof seal
_ Cutting can be done with drill blade or
rivet cutter for an aluminum-rivet with
ø4.8 mm.
_ When a rivet cutter is used for an
aluminum-rivet (except ø4.8 mm), a
steel-rivet, or a T-rivet with ø6.4 mm, it is
possible that the drill will spin abnormally
damaging the rivet hole and breaking the
rivet cutter.
_ When an ordinary cutter is used for a
waterproof-rivet with ø4.8 mm the
rivet can not be cut as it spins with
the cutter.
IN-15
T-Rivet
Before installation
After installation
Mandrel
Outer Inner
_ Large waterproof
rivet
_ Mandrel sticks out
after installation
Note