Toyota Celica 2005 Repair Manual page 1127

DI−926
3 Check airbag sensor assembly.
Instrument Panel Wire
P Squib
→ ←
P−
P+
DLC3
CG
TC
H01023
H02144 AB0118
H01076
H10600
OK
2005 CELICA (RM1131U)
DIAGNOSTICS
Airbag
Sensor
Assembly
ON
DTC B0108/52
H10617
− SUPPLEMENTAL RESTRAINT SYSTEM
PREPARATION:
(a) Connect the connector to the airbag sensor assembly.
(b) Using a service wire, connect P+ and P− of the instrument
panel wire connector on the front passenger airbag as-
sembly (P squib) side.
(c) Connect the negative (−) terminal cable to the battery,
and wait at least for 2 seconds.
CHECK:
(a) Turn the ignition switch to ON, and wait at least for 10 se-
conds.
(b) Clear the DTC stored in memory (See page DI−884).
(c) Turn the ignition switch to LOCK, and wait at least for 10
seconds.
(d) Turn the ignition switch to ON, and wait at least for 10 se-
conds.
(e) Check the DTC (See page DI−884).
OK:
DTC B0108/52 is not output.
HINT:
Codes other than code B0108/52 may be output at this time, but
they are not relevant to this check.
NG Replace airbag sensor assembly.
1126