Toyota Celica 2005 Repair Manual page 1154

4 Check side squib LH.
Side Squib LH
Airbag
→ ←
Sensor
Assembly
ON
DLC3
CG TC
H01018 AB0119
H10600
H01072
OK
From the results of the above inspection, the malfunctioning part can now be considered normal.
To make sure of this, use the simulation method to check. If the malfunctioning part can not be
detected by the simulation method, replace all SRS components including the wire harness.
2005 CELICA (RM1131U)
DIAGNOSTICS
PREPARATION:
(a)
(b)
(c)
(d)
CHECK:
(a)
(b)
DTC B0118/46
(c)
(d)
(e)
OK:
H13118
HINT:
Codes other than code B0118/46 may be output at this time, but
they are not relevant to this check.
− SUPPLEMENTAL RESTRAINT SYSTEM
Turn the ignition switch to LOCK.
Disconnect the negative (−) terminal cable from the bat-
tery, and wait at least for 90 seconds.
Connect the side airbag assembly LH (side squib LH)
connector.
Connect the negative (−) terminal cable to the battery,
and wait at least for 2 seconds.
Turn the ignition switch to ON, and wait at least for 10 se-
conds.
Clear the DTC stored in memory (See page DI−884).
Turn the ignition switch to LOCK, and wait at least for 10
seconds.
Turn the ignition switch to ON, and wait at least for 10 se-
conds.
Check the DTC (See page DI−884).
DTC B0118/46 is not output.
NG Replace side airbag assembly LH
(side squib LH).
1153
DI−953